WorkspaceElectronic Design Studio

Electronic Design Studio

Draw low-voltage circuit schematics, solve DC and RC response, place through-hole components and generate a checked copper and drill package.

Application guide

Verifying your session…

Using Electronic Design Studio

Take a low-voltage passive circuit from pin-level schematic through simulation and board fabrication output.

Circuit simulation · Board routing · Fabrication archive

Inputs and working data
DC input connectors, resistors and capacitors, schematic symbols and connections, reference ground, physical footprint placements and routed traces.
Working in the editor
Schematic sheet, pin connection editor, board placement and trace bends, physical checks and electrical solver.
What can I produce?
Operating point, transient voltage CSV, Gerber copper, masks and profile, plated XNC drills, component CSV, netlist and editable .electronics.json.
What are the limits?
Up to 80 parts, 24 V ideal DC inputs, linear resistors/capacitors, one copper layer, fixed through-hole footprints, 650 copper segments. Connectivity requires explicit pad endpoints.
Example
Modify divider resistance, verify node voltage, route all three nets, inspect Gerber and BOM output and reopen the stored design.
Back to the editor